Royer LabsModel SF-24VVacuum Tube, Stereo Ribbon Velocity MicrophoneOperation Instructions Manual & User GuideMade in U.S.A.
thumb and forefinger (Image 5). Rotate the drum so that the desired voltage appears in the window of the module (Image 6). Gently push the
secondary and fall into the category of conveniences or interface capabilities (such as digital or optical outputs).A good preamplifier should sound
You can perform a simple test to check for this condition (preferably done with a pair of headphones to avoid feedback). Plug one side
Unwanted magnetically induced noise (hum) can only come from external sources. Fortunately, simply repositioning a ribbon microphone often gets rid o
Drum Overhead & RoomPosition the SF-24V horizontally over the center point of the kit, two to three feet above the cymbals. For a centered snare
PianoThere are several positions that will give excellent results with the piano. Start with a distance of one foot to several feet from the kn
Specialized Stereo Recording TechniquesClassic Blumlein TechniqueFor many years, “coincident” microphone setups have been widely used for picking up s
element is at 90º to the performance and is the “side” microphone. If the microphone is to be mounted upside down, make the proper adjustm
Care and MaintenanceThe SF-24V is a solidly built, precision instrument. Following a few commonsense rules is all that is required to ensure pr
cloth, not to the microphone). Be very careful whenever working around the transducers to avoid contamination of the ribbon elements.Care for the SF-2
TABLE OF CONTENTSModel SF-24V Ribbon MicrophoneRevised 2009Introduction! 3SF-24V Vacuum Tube Stereo Ribbon Microphone! 3Active & Vacuum Tube Ribbo
SpecificationsAcoustic Operating Principle: ! Electro-dynamic pressure gradient with active electronicsPolar Pattern: ! ! ! Symmetrical Figure-8Generat
Polar PatternFrequency Response21
Wiring Diagram22
WarrantyPLEASE RETAIN YOUR ORIGINAL BILL OF SALE AS YOU WILL NEED TO PRESENT IT SHOULD YOU REQUIRE SERVICE UNDER THIS WARRANTY.TO VALIDA
IntroductionSF-24V Vacuum Tube Stereo Ribbon MicrophoneCongratulations on your purchase of a Royer Labs model SF-24V vacuum tube stereo r
DescriptionThe SF-24V vacuum tube stereo coincident ribbon microphone is the only microphone of its kind available, combining high audio
Although spaced microphones can produce similar stereophonic results, such recordings when summed to mono can suffer from “comb filter” effect
lifting the Pin-1 connection from either connector (preferably done at the input amplifier or patch bay) will usually cure the problem.3. Be certai
5. Avoid dropping the microphone. An accidental fall to a hard surface could stretch one or both ribbons and, depending on the nature of the fall,
Hold the mic by placing the transducer (ribbon element) end in the palm of one hand. While holding the shock mount in the other hand, gen
Power Supply Input ModuleThe power OFF/ON switch and the Power Input Module are located on the rear side of the power supply (Image
Kommentare zu diesen Handbüchern